How much psi should I put in my bike shock?

How much air should I put in my bike shocks?

Eyeball it or use a ruler to measure. If less than 30 percent of the stanchion is showing below the o-ring, unscrew the valve cap on your shock and, using a shock pump, add air—about 10 PSI at a time. If more is showing release air by tapping on the shock pump release valve one tap at a time.

What PSI should my shock be?

A good rule of thumb for inflating air shocks is to add 1psi of air for every pound you weigh. Therefore if you weigh 140lb, then begin the set-up process at 140psi. Remember to use an accurate shock pump, as old pumps often have leaks and faulty pressure dials.

What PSI should bike suspension be?

Air Pressure Guide for Suspension Forks

Air Pressure Guide For All Air Front Suspension Forks
80-115 psi 60-115 psi
140-160 lbs. 115-130 psi 95-130 psi
160-180 lbs. 130-145 psi 110-145 psi
180-200 lbs. 145-160 psi 125-160 psi

What is the max psi for air shocks?

The Max-Air® shock absorber is. Designed to maintain level vehicle height, they can be inflated or deflated as needed…from 20 psi to 150 psi with the vehicle loaded. Capacity is limited by vehicle suspension, tires and transmission. See vehicle owner’s manual for details.

What PSI should rear shocks be?

Do not exceed 300 psi, the maximum FLOAT air pressure!

How much PSI is a Fox Float?

Page 7 2004 manual: “Note: Average setting range is from 50 to 300 PSI. DO NOT EXCEED 300 PSI. Replace the air valve cap before riding.”

What do shock spacers do?

The spacers real job is to raise ride height. (set truck down, push it to the floor and let it rebound, thats your ride height.) However a nice side-effect, is that it gives the feel of stiffer springs.

How can I make my suspension softer?

How to Soften Car Suspension

  1. Install softer shocks and struts. As the primary component that affects your vehicle’s ride quality, shocks and struts have a very big impact. …
  2. Adjust the shocks to a softer setting, if you have adjustable shocks. …
  3. Install softer springs. …
  4. Replace the bushings in the suspension.

Do volume spacers reduce travel?

“Adding a spacer will decrease the air volume, so the air spring will build more pressure at bottom out. This is good for riders that are bottoming prematurely or need more bottom out support. And vice versa, removing a spacer will allow the fork to achieve full travel easier.”

How many PSI can I put in my air bags?

Expert Reply: No, the minimum air pressure is 5 psi and the maximum is 100 psi. The 40 figure comes into play based off of the instructions which state that generally the system can support 40 pounds per 1 psi of air pressure. I have linked the installation instructions for Air Lift kit # AL88299.

What is the most common problem with air shocks?

One of the most common air suspension problems is a leaking air spring. With time, the rubber components of these parts will deteriorate, creating holes and tears and causing air leaks.

Can you run air shocks with no air?

Without any air in the shock, it should just work as a regular shock. The air bladder and the dampening section are totally separate.

IT IS INTERESTING:  What does a Power Commander do for your bike?
Cycling