The first thing you need to do is make sure that your bike chain does indeed need shortening. The best way to do this is by taking some measurements. … If your chain is the right length you should get about 12 inches or just a little more.
Are all bicycle chains the same length?
All modern bicycle chains are made to the “one-half inch pitch” standard, meaning from rivet to rivet is nominally 0.5 inches. The sprocket teeth are cut for this same one-half inch standard to accept bicycle chains. However, this does not mean all makes and models of chains are interchangeable.
Can you take links out of a bike chain?
If your chain does not have a master link, you’ll have to use a chain tool to break the chain. Open the master link, slide it off, and put it someplace where it won’t get lost. … Some master links are also disposable, and can only be removed by bending them apart with needle-nose pliers or a specialized tool.
How do you cut bike chain length?
Chains cannot be cut to 52-1/4″, 53-1/8″, or even 52-1/2″. It is possible to determine chain length from industrial drive train equations, and then cut the chain before installing it on the bike. Begin by counting the number of teeth on the largest front sprocket and largest rear.
What is a 3 32 chain?
3/32″ (0.094″, 2.30 mm) chain is used on derailer equipped bicycles that have more than 3 cogs at the rear. Even somewhat narrower chain, typically . 090″ or 2.29 mm between the inner plates, is used for derailer-equipped bicycles with 9 or more sprockets at the rear.
How often should I change my bike chain?
To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point.
Do all bike chains have a master link?
Do all bike chains have a master link? Nope, not all chains have master links. If your bicycle has derailleurs, it means it’s unlikely that your bike’s chain will have a master link.
How do I know if my bike chain is too short?
You should also see two slight bends at each jockey wheel of the rear derailleur. If the chain is too short, this shift is difficult to make and the derailleur cage is stretched out and almost parallel to the chainstay. If the chain is really short, then you might not even be able to shift into the largest cog.